What does a ping 127.0 0.1 Command do?
- When the technician ping the loopback address 127.0 0.1 What is tested?
- What happens when you ping?
- What is a ping loopback test?
- How do I ping a gateway address?
When the technician ping the loopback address 127.0 0.1 What is tested?
127.0. 0.1 is the local loopback address on any TCP/IP network device. By pinging this address, the technician is verifying the TCP/IP protocol stack on that particular device.
What happens when you ping?
Ping works by sending an Internet Control Message Protocol (ICMP) Echo Request to a specified interface on the network and waiting for a reply. When a ping command is issued, a ping signal is sent to a specified address. When the target host receives the echo request, it responds by sending an echo reply packet.
What is a ping loopback test?
To verify that your TCP/IP software is installed, started, and working properly, ping the loopback interface. You can perform the test without being connected to a physical line or network. IBM® i reserves the IP address 127.0.
How do I ping a gateway address?
Ping your default gateway:1On the endpoint with the Management Server, press Windows Key + R.2Type cmd and press Enter.3In the console, type ipconfig and press Enter.4If you see an entry like this: Default Gateway..... X.X.X.X. then type ping X.X.X.X. (where X.X.X.X is the default gateway's IP).5Press Enter.
Related Questions
-
Anonymous2 weeks ago
Expert answer2 weeks ago -
Anonymous2 weeks ago
Expert answer2 weeks ago -
Anonymous2 weeks ago
Expert answer2 weeks ago -
Anonymous2 weeks ago
Expert answer2 weeks ago -
Anonymous2 weeks ago
Expert answer2 weeks ago -
Anonymous2 weeks ago
Expert answer2 weeks ago -
Anonymous2 weeks ago
Expert answer2 weeks ago